Bug: The Parcel Editor's join command causes control point locations to change
【相关信息】
Article ID: 44889
Bug Id: BUG-000087677
Software:
ArcGIS for Desktop Advanced 10.3
ArcGIS for Desktop Standard 10.3
Platforms: N/A
【BUG描述】
Using the Parcel Editor's join functionality causes control point locations to be altered.
【BUG原因】
Control point changes can only occur if the initial release of ArcGIS 10.3 for Desktop Parcel Fabric General Maintenance Patch, dated 04-22-2015, has been installed. If the fabric data is stored in a projection that is not in meters, or is not in a geographic coordinate system, and if the join command is used to link a fabric parcel point directly to a control point.
Article ID: 44889
Bug Id: BUG-000087677
Software:
ArcGIS for Desktop Advanced 10.3
ArcGIS for Desktop Standard 10.3
Platforms: N/A
【BUG描述】
Using the Parcel Editor's join functionality causes control point locations to be altered.
【BUG原因】
Control point changes can only occur if the initial release of ArcGIS 10.3 for Desktop Parcel Fabric General Maintenance Patch, dated 04-22-2015, has been installed. If the fabric data is stored in a projection that is not in meters, or is not in a geographic coordinate system, and if the join command is used to link a fabric parcel point directly to a control point.
1 个回复
EsriSupport
赞同来自:
Until there is an opportunity to install the updated patch
ArcGIS 10.3 for Desktop Parcel Fabric General Maintenance Patch, the problem can be avoided by setting the data frame projection to a metric equivalent of the original non-metric one. For example, changing:
'NAD_1983_StatePlane_Michigan_South_FIPS_2113(IntFeet)'
to the metric equivalent of:
'NAD_1983_StatePlane_Michigan_South_FIPS_2113'
This does not impact the units that have been set on the fabric plans for editing and entering distances for parcels, however for adding new control point coordinates, it is necessary to convert to metric for the entered coordinates, or else use the original non-metric map document with a data frame for the specific workflow of adding control points.
【创建及修改时间】
Created: 6/11/2015 Last Modified: 6/12/2015
【原文链接】
http://support.esri.com/en/kno ... 44889
要回复问题请先登录或注册