Bug: The Parcel Editor's Regenerate command applies incorrect bearings on some curves' radial lines
【相关信息】
Article ID: 43241
Bug Id: NIM103712
Software:
ArcGIS for Desktop Advanced 10.2.2
ArcGIS for Desktop Standard 10.2.2
Platforms: N/A
【BUG描述】
The Parcel Editor's Regenerate command applies incorrect bearings to the radial lines of curves that have a central angle greater than 180 degrees.
【BUG原因】
These incorrect bearings can only occur if the initial release of ArcGIS 10.2.2 for Desktop Parcel Fabric General Maintenance Patch, dated 10-01-2014, has been installed. These incorrect values are written only if the Regenerate command is then run on parcels with curves greater than 180 degrees.
Article ID: 43241
Bug Id: NIM103712
Software:
ArcGIS for Desktop Advanced 10.2.2
ArcGIS for Desktop Standard 10.2.2
Platforms: N/A
【BUG描述】
The Parcel Editor's Regenerate command applies incorrect bearings to the radial lines of curves that have a central angle greater than 180 degrees.
【BUG原因】
These incorrect bearings can only occur if the initial release of ArcGIS 10.2.2 for Desktop Parcel Fabric General Maintenance Patch, dated 10-01-2014, has been installed. These incorrect values are written only if the Regenerate command is then run on parcels with curves greater than 180 degrees.
1 个回复
EsriSupport
赞同来自:
To correct this problem, install the updated version of the patch:
ArcGIS 10.2.2 for Desktop Parcel Fabric General Maintenance Patch
Once the updated patch has been installed, follow these steps:
【创建及修改时间】
Created: 10/14/2014
Last Modified: 10/15/2014
【原文链接】
http://support.esri.com/en/kno ... 43241
要回复问题请先登录或注册